Filmfaced Plywood
The formwork construction process is made more efficient
because of the use of modern formfork technology, which
includes the use of phenolic filmfaced plywood. It is
coated on both sides with phenolic film and is suitable
for multiple use and smoother surface. The number of times
used depend on the followings:-
How to get the most out of filmfaced plywood
1. Sealing of Edges
Phenolic fabric film faced plywood edges are fully sealed
at the factory and it is most important that all edges
remain sealed. To obtain full value from a phenolic
fabric film faced sheet any recut edges should be sealed
as soon as possible with waterproof paint
2. Sealing of Holes
Any holes made in fabric film faced formwork panels
should also be sealed to prevent water entering. If
water does enter it may cause swelling around the holes.
3. Cleaning and Repair
To obtain full life, cleaning should be carried out
immediately after each use. Phenolic fabric film faced
plywood may be wiped with release agent or cleaned with
water and stiff brush. It may be necessary to use a
hardwood scraper but care should be taken not to damage
the plywood face. Do not use a wire brush or sharp metal
scraper to dislodge hardened concrete.
4. Storage
Always clean and repair the formwork panels before storage.
The formwork should then be stacked off the ground on
level supports and under cover. Framed formwork panels
should be stacked alternately face to face and back
to back to avoid face damages by bolts etc. If panels
are wet, do not allow them to dry too rapidly
|
